tag:blogger.com,1999:blog-2090121141266718432.post7440104090313287236..comments2023-05-29T08:02:26.948-07:00Comments on CGMS Watch: Direct control of Pebble with ArduinoUnknownnoreply@blogger.comBlogger2125tag:blogger.com,1999:blog-2090121141266718432.post-72478047644276513472015-12-07T18:52:23.481-08:002015-12-07T18:52:23.481-08:00No real processing issue, will do it on the phone ...No real processing issue, will do it on the phone though, since that's not static sensitive. Calibration at it's simplest is y=mx+b.<br />b=30000, y is mg/dl value from your finger stick, and x is the isig value from the sensor. Get your slope. Once you have a few data points calculate you b (intercept) value also, although allot of the time you are better off with 30,000.<br /><br />Anyway push the slope/intercept values to the watch and feed it isig values from the phone or the device, and let it calculate your mg/dl.Donhttps://www.blogger.com/profile/12447399246832399363noreply@blogger.comtag:blogger.com,1999:blog-2090121141266718432.post-53346984079720467082015-12-07T07:05:04.641-08:002015-12-07T07:05:04.641-08:00How does the calibrations work? It sounds like yo...How does the calibrations work? It sounds like you need a fast processor to do some intense calculations? Is there something, somewhere, that describes this process?Anonymoushttps://www.blogger.com/profile/00194131421352805724noreply@blogger.com